Command Line Reference Guide

Related
Commands
dcb-input — creates a DCB input policy.
show dcb
Displays the data center bridging status, the number of PFC-enabled ports, and the number of PFC-
enabled queues.
S6000
Syntax
show dcb [stack-unit unit-number] [port-set port-set port-set
number]
Parameters
unit number Enter the DCB unit number. The range is from 0 to 5.
port-set
number
Enter the port-set number.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Specify a stack-unit number on the Master switch in a stack.
Example
Dell# show dcb
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)
show interface pfc
Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link delay.
S6000
Syntax
show interface port-type slot/port pfc {summary | detail}
460
Data Center Bridging (DCB)