Command Line Reference Guide

To disable debugging, use the no debug ip bgp ipv4 multicast dampening
command.
Parameters
dampening Enter the keyword dampening to debug route flap
dampening information.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP support for the E-Series.
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
S6000
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] dampened-paths
Parameters
vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of
the VRF to view routes that are affected by a specific
community list corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol
433