Command Line Reference Guide

holdtime Enter a number for the time interval, in seconds, between
the last keepalive message and declaring the router dead.
The range is from 3 to 65535. The default is 180 seconds.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the
internet and connecting multicast topologies between BGP and autonomous systems (ASs).
Dell Networking OS MBGP is implemented as per IETF RFC 1858.
BGPv4 is supported in the following:
Dell Networking
OS Version
Platform Support
7.8.1.0, MBGP for
IPv4 Multicast Only
S-Series
debug ip bgp dampening
View information on routes being dampened.
S6000
Syntax
debug ip bgp [vrf test | ipv4 {unicast | multicast} | ipv6
{unicast | multicast} dampening
432
Border Gateway Protocol