Command Line Reference Guide

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF to view ipv4–unicast route information
corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
network (OPTIONAL) Enter the network address (in dotted decimal
format) of the BGP network to view information only on that
network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format)
of the BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view
all routes with a common prefix.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added the add-path option to the S4810. Output on the
S4810 shows the ADDPATH parameters.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
When you enable the bgp non-deterministic-med command, the show ip
bgp command output for a BGP route does not list the INACTIVE reason.
In BGP, this command displays the exact reason why the route is discarded.
The following describes the show ip bgp command shown in the following
example.
Border Gateway Protocol
397