Command Line Reference Guide

Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced the limit keyword on the S4810.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
After you configure a peer group as passive, assign it a subnet using the neighbor
soft-reconfiguration inbound command.
For passive eBGP limits, the Remote AS must be different from the AS for this
neighbor.
Related
Commands
neighbor soft-reconfiguration inbound — assigns a subnet to a dynamically
configured BGP neighbor.
neighbor remote-as — assigns an indirectly connected AS to a neighbor or peer
group.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
S6000
Syntax
neighbor {ip-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ip-address | peer-
group-name} remote-as number command.
Parameters
ip-address Enter the IP address of the neighbor to enter the remote AS
in its routing table.
378
Border Gateway Protocol