Command Line Reference Guide

no prepend Specifies that local AS values do not prepend to
announcements from the neighbor.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
If a local-as is configured, BGP does not allow for the configuration of BGP
confederation. Similarly, if BGP confederation is configured, then BGP does not
allow the configuration of local-as.
This command automatically restarts the neighbor session for the configuration to
take effect.
Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
neighbor maximum-prefix
Control the number of network prefixes received.
S6000
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum
[threshold] [warning-only]
To return to the default values, use the no neighbor {ip-address | peer-
group-name
} maximum-prefix maximum command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
372
Border Gateway Protocol