Command Line Reference Guide

Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to apply the distribute list
filter to all routers in the peer group.
prefix-list-
name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to
allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
Other BGP filtering commands include: neighbor filter-list, ip as-path
access-list, and neighbor route-map.
Related
Commands
neighbor route-map — assigns a route map to a neighbor or peer group.
neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
S6000
Syntax
neighbor {ip-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ip-address |
peer-group-name} ebgp-multihop command.
Border Gateway Protocol
369