Command Line Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.2.1.0 Introduced.
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging. If no
neighbor is specified, debug turns on for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
S6000
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] updates [in | out] command.
Parameters
in (OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
prefix-list
prefix-list-
name
(OPTIONAL) Enter the keyword prefix-list then the
name of an established prefix list. If the prefix list is not
configured, the default is permit (to allow all routes).
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-
name
(OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group.
Command
Modes
EXEC Privilege
358
Border Gateway Protocol