Command Line Reference Guide

Command
History
Version 9.0.2.0 Introduced on the S6000.
Usage
Information
When you enter the reload command and the system reboots, you will not be
prompted for a password to enter the EXEC Privilege mode (normally you are
required to enter the enable command).
If your console or Telnet session expires after you used the ignore enable-
password command, you are prompted for an enable password when you re-
establish the session
Related
Commands
reload — Exit from this mode and reload FTOS.
ignore startup-config
During a reload, do not load the startup-config file.
S6000
Syntax ignore startup-config
Defaults disabled
Command
Modes
BOOT_USER
Command
History
Version 9.0.2.0 Introduced on the S6000.
Usage
Information
Use this command if you have authentication procedures in the startup-config
other than the enable-password setting.
interface management ethernet ip address
Assign an IP address to the Management Ethernet interface.
S6000
Syntax [no] interface management ethernet ip address ip-address mask
To delete the IP address, enter no interface management ethernet ip address.
Defaults Not configured.
316
Boot Command Line Interface