Command Line Reference Guide

8
Boot Command Line Interface
BCLI commands are supported on the S6000 platform only.
S6000
To access this BOOT_USER mode, first boot your Dell Networking platform. When you see the “Press
ESC to stop auto-boot”, press the ESC key to log into BCLI
You enter BOOT_USER mode immediately, as indicated by the BOOT_USER# prompt.
NOTE: All commands in this chapter are in Boot_User mode. These commands are supported on
the Dell Networking platform.
You cannot use the Tab key to complete commands in this mode.
boot change
Change the primary, secondary, or default Dell Networking OS boot configuration.
S6000
Syntax boot change primary | secondary | default}
Parameters
primary
Enter the keyword primary to configure the boot parameters
used in the first attempt to boot Dell Networking OS.
secondary
Enter the keyword secondary to configure boot parameters
used if the primary operating system boot selection is not
available.
default
Enter the keyword default to configure boot parameters
used if the secondary operating system boot parameter
selection is not available. You can configure this option to
any of the available type, for example flash/usb/ftp/tftp.
Defaults None
310
Boot Command Line Interface