Command Line Reference Guide

set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
S6000
Syntax
set weight weight
To delete a weight specification, use the no set weight weight command.
Parameters
weight Enter a number as the weight used by the route meeting the
route map specification. The range is from 0 to 65535. The
default is router-originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, the
routes with a higher weight are preferred.
Defaults router-originated = 32768; all other routes = 0
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
If you do not use the set weight command, router-originated paths have a
weight attribute of 32768 and all other paths have a weight attribute of zero.
258
Access Control Lists (ACL)