Command Line Reference Guide

show mac access-lists
Display all of the Layer 2 ACLs configured in the system, whether or not they are applied to an interface,
and the count of matches/mismatches against each ACL entry displayed.
S6000
Syntax
show mac access-lists [access-list-name] [interface interface]
[in | out]
Parameters
access-list-
name
Enter the name of a configured MAC ACL, up to 140
characters.
interface
interface
Enter the keyword interface then the one of the following
keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword port-
channel and then enter a number. The C-Series and S-
Series range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet and then enter the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE and then enter the slot/port information.
• For a VLAN interface, enter the keyword VLAN followed
by the vlan id.
in | out Identify whether ACL is applied on ingress or egress side.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.4.1.0 Introduced.
212
Access Control Lists (ACL)