Command Line Reference Guide

maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
S6000
Syntax maximum dynamic-routes limit {warn-threshold threshold-value |
warning-only}
To remove the limit on the maximum number of routes used, use the no maximum
dynamic-routes command.
Parameters
limit Maximum number of routes allowed in a VRF. Valid range is
from 1 to 16,000 (or maximum allowable for that platform if
smaller value).
warning-
threshold
Warning threshold value is expressed as a percentage of the
limit value. When the number of routes reaches the specified
percentage of the limit, a warning message is generated.
Valid range is 1 to 100. When warn-threshold is used, once
the limit is reached, additional dynamic routes will not be
allowed.
warning-only When the warning-only option is used, a syslog message will
be thrown when maximum number of dynamic routes
reaches the limit. Additional dynamic routes will still allowed.
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
Command
Modes
CONFIGURATION-VRF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OSCommand Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Introduced on the S–Series.
Usage
Information
If the maximum route limit is not specified for a VRF, then it has unlimited space
that extends to the maximum number of entries allowed for the system. This
command is not applicable to the default and management VRFs.
1454
Virtual Routing and Forwarding (VRF)