Manualshelf

Command Line Reference Guide

ManualsBrandsDell ManualsNetworkingNetworking S6000
1451145214531454145514561457145814591460
Dell(conf-if-te-7/45)#int te 7/46
Dell(conf-if-te-7/46)#no shut
Dell(conf-if-te-7/46)#ip vrf forwarding red
Dell(conf-if-te-7/46)#ip add 100.1.1.1/24
Dell(conf-if-te-7/46)#
Dell(conf-if-te-7/46)#
Dell(conf-if-te-7/46)#
Dell(conf-if-te-7/46)#show config
!
interface TenGigabitEthernet 7/46
ip vrf forwarding red
ip address 100.1.1.1/24
no shutdown
Dell(conf-if-te-7/46)#
interface management
Associates a management port with a management VRF.
Syntax
interface management
To delete the association between a management port and a management VRF,
use the no interface management command.
Defaults None.
Command
Modes
VRF MODE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to associate a management port with a management VRF.
When you execute this command, the management ports corresponding to both
the ACTIVE unit as well as the STANDBY unit are associated with the management
VRF.
Virtual Routing and Forwarding (VRF)
1453