Command Line Reference Guide

vrf vrf-name (Optional) Enter the keyword vrf and then the name of the
VRF to enable the logging process in VRF mode.
NOTE: Use this attribute to specify the VRF that is used
to contact the host. By default, the default VRF is used.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Added udp and tcp keywords for the S4810, S4820T, S6000,
Z9000, and MXL.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.1.0 Added support for IPv6.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Multiple logging servers of both IPv4 and/or IPv6 can be configured.
Related
Commands
logging on — enables the logging asynchronously to logging buffer, console,
Syslog server, and terminal lines.
logging trap — enables logging to the Syslog server based on severity.
1366
Simple Network Management Protocol (SNMP) and Syslog