Command Line Reference Guide

Example
Dell# conf
Dell#(conf) snmp-server view rview 1.3.6.1 included
Related
Commands
show running-config snmp — displays the SNMP running configuration.
snmp-server vrf
Configures an SNMP agent to bind to a specific VRF.
Syntax
snmp-server vrf vrf-name
To undo the SNMP agent configuration, use the no snmp-server vrf vrf-
name command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
associate an SNMP agent with that VRF.
Defaults Not Enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to bind an SNMP agent to a VRF. The SNMP agent processes
the requests from the interfaces that belong to the specified VRF. If no VRF is
specified, then the default VRF is used.
Related
Commands
show snmp user — displays the information configured on each SNMP user name.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
S6000
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status
command.
1360
Simple Network Management Protocol (SNMP) and Syslog