Command Line Reference Guide

priv des56 (OPTIONAL) Enter the keywords priv des56 to initiate a
privacy authentication level setting using the CBC-DES
privacy authentication algorithm (des56).
priv password (OPTIONAL) Enter a text string (up to 20 characters long)
password that enables the host to encrypt the contents of
the message it sends to the agent. Minimum: eight
characters long.
access access-
list-name
(Optional) Enter the standard IPv4 access list name (a string
up to 16 characters long).
ipv6 access-
list-name
(Optional) Enter the keyword ipv6 then the IPv6 access list
name (a string up to 16 characters long).
access-list-
name ipv6
access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
NOTE: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP. TCP and
ICMP rules are not valid for SNMP. In IPv6 ACLs port rules are not valid for
SNMP.
1356
Simple Network Management Protocol (SNMP) and Syslog