Command Line Reference Guide

snmp-server community — configures a new community SNMPv1 or SNMPv2c.
snmp-server location
Configure the location of the SNMP server.
S6000
Syntax
snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
text Enter an alpha-numeric text string, up to 55 characters long.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server packetsize
Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a
reply, use the
snmp-server packetsize global configuration command.
S6000
Syntax
snmp-server packetsize byte-count
Parameters
byte-count Enter one of the following values 8, 16, 24 or 32. Packet sizes
are 8000 bytes, 16000 bytes, 32000 bytes, and 64000 bytes.
1352
Simple Network Management Protocol (SNMP) and Syslog