Command Line Reference Guide

Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.2
Added support for the access parameter.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The following Example specifies the group named harig as a version 3 user
requiring both authentication and encryption and read access limited to the read
named rview.
NOTE: The number of configurable groups is limited to 16 groups.
Example
Dell#conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related
Commands
show snmp group — displays the group name, security model, view status, and
storage type of each group.
show running-config — displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
S6000
Syntax
snmp-server host ip-address | ipv6-address [vrf vrf-name] traps
| informs [version 1 | 2c | 3] [auth | no auth | priv]
[community-string] [udp-port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [vrf
vrf-name] traps | informs [version 1 | 2c | 3] [auth | noauth |
priv] [community-string] [udp-port number] [notification-type]
command.
Parameters
ip-address Enter the keyword host then the IP address of the host
(configurable hosts is limited to 16).
1348
Simple Network Management Protocol (SNMP) and Syslog