Command Line Reference Guide

Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Enabling RSA authentication allows the user to log in without being prompted for a
password. In addition, the OpenSSH compatible SSHv2 RSA public key must be
added to the list of authorized keys (ip ssh rsa-authentication my-
authorized-keys device://filename
command).
ip ssh server
Configure an SSH server. SSH server is enabled by default.
S6000
Syntax
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
ip ssh server {enable | port port-number} [version {1 | 2}]
To disable SSH server functions, use the no ip ssh server enable command.
Parameters
enable Enter the key word enable to start the SSH server.
port port-
number
(OPTIONAL) Enter the keyword port then the port number
of the listening port of the SSH server. The range is from 1 to
65535. The default is 22.
[version {1 | 2}] (OPTIONAL) Enter the keyword version then the SSH
version 1 or 2 to specify only SSHv1 or SSHv2.
1294
Security