Command Line Reference Guide

ip ssh rekey
Configures the time rekey-interval or volume rekey-limit threshold at which to re-generate the SSH key
during an SSH session.
Syntax
ip ssh rekey [time rekey-interval] [volume rekey-limit]
To reset to the default, use no ip ssh rekey [time rekey-interval]
[volume rekey-limit] command.
Parameters
time minutes Enter the keywords time then the amount of time in
minutes. The range is from 10 to 1440 minutes. The default is
60 minutes
volume rekey-
limit
Enter the keywords volume then the amount of volume in
megabytes. The range is from 1 to 4096 to megabytes. The
default is 1024 megabytes
Defaults The default time is 60 minutes. The default volume is 1024 megabytes.
Command
Modes
CONFIGURATION mode
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, MXL
ip ssh pub-key-file
Specify the file used for host-based authentication.
S6000
Syntax
ip ssh pub-key-file {WORD}
Parameters
WORD Enter the file name for the host-based authentication.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Security
1291