Command Line Reference Guide

reached. If the authentication fails after all allowed attempts, the interface is moved
to the authentication failed VLAN.
After the authentication VLAN is assigned, the port-state must be toggled to restart
authentication. Authentication occurs at the next re-authentication interval (dot1x
reauthentication).
Related
Commands
dot1x port-control — enables port-control on an interface.
dot1x guest-vlan — configures a guest VLAN for non-dot1x devices.
show dot1x interface — displays the 802.1X information on an interface.
dot1x auth-server
Configure the authentication server to RADIUS.
S6000
Syntax
dot1x auth-server radius
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
dot1x guest-vlan
Configure a guest VLAN for limited access users or for devices that are not 802.1X capable.
S6000
Syntax
dot1x guest-vlan vlan-id
To disable the guest VLAN, use the no dot1x guest-vlan vlan-id command.
Security
1273