Command Line Reference Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
dot1x authentication (Configuration) — enables dot1x globally.
dot1x auth-fail-vlan
Configure an authentication failure VLAN for users and devices that fail 802.1X authentication.
S6000
Syntax
dot1x auth-fail-vlan vlan-id [max-attempts number]
To delete the authentication failure VLAN, use the no dot1x auth-fail-vlan
vlan-id [max-attempts number] command.
Parameters
vlan-id Enter the VLAN Identifier. The range is from 1 to 4094.
max-attempts
number
(OPTIONAL) Enter the keywords max-attempts then
number of attempts desired before authentication fails. The
range is from 1 to 5. The default is 3.
Defaults 3 attempts
Command
Modes
CONFIGURATION (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series, S-Series, and E-Series.
Usage
Information
If the host responds to 802.1X with an incorrect login/password, the login fails. The
switch attempts to authenticate again until the maximum attempts configured is
1272
Security