Command Line Reference Guide

tacacs-server vrf
Create an association between a TACACS server group and a VRF and source interface..
Syntax
tacacs-server vrf vrf-name [source-interface interface]
To delete the association between a TACACS server group and a VRF and source
interface, use the no tacacs-server vrf vrf-name [source-interface
interface] command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
associate a TACACS server group with that VRF.
interface Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16838.
• For the Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
TACACS SERVER GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
You can use this command to associate a group of TACACS servers with a VRF and
source interface. You can configure the source interface only with the VRF
attribute and source interface is optional with the VRF attributes.
Security
1269