Command Line Reference Guide

Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
You can associate a TACACS server group with a VRF.
Example
Dell(conf)#tacacs-server group group1
Dell(conf-tacacs-group)#tacacs-server host 1.1.1.1 key secret
Dell(conf-tacacs-group)#tacacs-server host 2.2.2.2 key secret
Dell(conf-tacacs-group)#tacacs-server vrf vrf1 source-
interface tengigabitethernet 0/36
Dell(conf-tacacs-group)#show config
!
tacacs-server group group1
tacacs-server vrf vrf1 source-interface TenGigabitEthernet 0/36
tacacs-server host 1.1.1.1 key 7 9a2f3ec0c65c6f41
tacacs-server host 2.2.2.2 key 7 9a2f3ec0c65c6f41
Dell(conf-tacacs-group)#
Related
Commands
aaa authentication login — specifies the login authentication method.
tacacs-server key — configures a TACACS+ key for the TACACS server.
tacacs-server host
Specify a TACACS+ host.
S6000
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address}
[port number] [timeout seconds] [key key]
Parameters
hostname Enter the name of the TACACS+ server host.
ipv4-address |
ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of the TACACS+ server host.
port number (OPTIONAL) Enter the keyword port then a number as the
port to be used by the TACACS+ server. The range is from
zero (0) to 65535. The default is
49.
timeout
seconds
(OPTIONAL) Enter the keyword timeout then the number of
seconds the switch waits for a reply from the TACACS+
server. The range is from 0 to 1000. The default is 10
seconds.
key key
(OPTIONAL) Enter the keyword key then a string up to 42
characters long as the authentication key. This
authentication key must match the key specified in the
tacacs-server key for the TACACS+ daemon.
Defaults Not configured.
1266
Security