Command Line Reference Guide

timeout login response
Specify how long the software waits for the login input (for example, the user name and password) before
timing out.
S6000
Syntax
timeout login response seconds
To return to the default values, use the no timeout login response
command.
Parameters
seconds
Enter a number of seconds the software waits before logging
you out. The range is:
• VTY: the range is from 1 to 30 seconds, the default is 30
seconds.
• Console: the range is from 1 to 300 seconds, the default
is 0 seconds (no timeout).
• AUX: the range is from 1 to 300 seconds, the default is 0
seconds (no timeout).
Defaults See the defaults settings shown in Parameters.
Command
Modes
LINE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The software measures the period of inactivity defined in this command as the
period between consecutive keystrokes. For example, if your password is
“password” you can enter “p” and wait 29 seconds to enter the next letter.
1250
Security