Command Line Reference Guide

Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
pre-Version
6.1.1.1
Introduced on the E-Series
Usage
Information
Use the default pre-defined profiles or configure your own profile. You cannot
delete the pre-defined profiles or their default values. This command enables
WRED configuration mode —(conf-wred).
Related
Commands
threshold — specifies the minimum and maximum threshold values of the WRED
profile.
rate shape
Define the rate-shaping method to be either as a measure of bytes or packets for each of the hierarchical
QoS (HQoS) nodes at the leaf level to be applied to each queue.
S6000
Syntax
[no] rate-shape [kbps | pps] peak-rate [burst-KB/Packets]
[committed [kbps | pps] committed-rate [burst-KB/Packets]]
Parameters
kbps Enter the keyword kbps to specify the committed rate limit in
Kilobits per second (Kbps). Specify this value as a multiple of
64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
pps Enter the keyword pps to specify the committed rate limit in
packets per second (pps). The range is from 1 to 268000000.
The default granularity is Megabits per second (Mbps).
committed-
rate
Define the committed rate, which is the guaranteed or
minimum confirmed rate for the packets. Specify this value
as a multiple of 64 if you specify the committed rate in Kbps.
The range is from 0 to 40000000 for Kbps. The range is
from 1 to 268000000 for pps. The range is from 0 to 40000
for Mbps (which is the default measure for rate limits if you
do not explicitly configure Kbps or pps)
Quality of Service (QoS)
1155