Command Line Reference Guide

test cam-usage
Check the Input Policy Map configuration for the CAM usage.
S6000
Syntax
test cam-usage service-policy input policy-map stack-unit
{[number port-set portpipe number] | [all]}
Parameters
policy-map Enter the policy map name.
stack-
unitnumber
(OPTIONAL) Enter the keyword stack-unit then the stack-
unit slot number.
port-set
portpipe
number
Enter the keywords port-set then the stack-unit port pipe
number. The range is from 0 or 1.
stack-unit all (OPTIONAL) Enter the keywords stack-unit all to indicate
all stack-unit.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
This feature allows you to determine if the CAM has enough space available before
applying the configuration on an interface.
An input policy map with both Trust and Class-map configuration, the Class-map
rules are ignored and only the Trust rule is programmed in the CAM. In such an
instance, the Estimated CAM output column contains the size of the CAM space
required for the Trust rule and not the Class-map rule.
The following describes the text cam-usage service-policy input
policy-map stack-unit
command shown in the following example.
Quality of Service (QoS)
1147