Command Line Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Use this command to specify the name of the output QoS policy. Once output
policy is specified, rate-shape, scheduler strict, bandwidth-percentage, and WRED
can be defined. This command enables the qos-policy-output configuration mode
—(conf-qos-policy-out).
When rate-shape in QoS policy is applied both on queue level and aggregate
mode, the queue-based shaping occurs first followed by the aggregate rate
shaping.
Related
Commands
bandwidth-percentage — assigns weight to the class/queue.
wred — assigns yellow or green drop precedence.
rate-police
Specify the policing functionality on incoming traffic.
S6000
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of 64.
The range is from 0 to 40000000. The default granularity is
Megabits per second (Mbps).
committed-
rate
Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 40000.
The default is the same as designated for committed-rate.
1132
Quality of Service (QoS)