Command Line Reference Guide

Up to 64 IP DSCP values can be matched in one match statement. For example, to
indicate IP DCSP values 0 1 2 3 4 5 6 7, enter either the match ip dscp
0,1,2,3,4,5,6,7 or match ip dscp 0-7 command.
NOTE: Only one of the IP DSCP values must be a successful match criterion,
not all of the specified IP DSCP values must match.
Related
Commands
class-map — identifies the class map.
match ip precedence
Use IP precedence values as a match criteria.
S6000
Syntax
match {ip | ipv6 | ip-any} precedence ip-precedence-list [set-
ip-dscp value]
To remove IP precedence as a match criteria, use the no match {ip | ipv6 |
ip-any} precedence ip-precedence-list [[multicast] set-ip-dscp
value] command.
Parameters
ip Enter the keyword ip to support IPv4 traffic.
ipv6 Enter the keyword ipv6 to support IPv6 traffic.
ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
ip-
precedence-list
Enter the IP precedence value(s) as the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 7.
set-ip-dscp
value
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command
Modes
CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Added support for the ipv6 and ip-any options on the Z9000,
S6000, S4820T, S4810, MXL.
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
1124
Quality of Service (QoS)