Command Line Reference Guide

class-map-
name
Enter a name of the class for the class map in a character
format (32 character maximum).
cpu-qos Enter the keyword cpu-qos to assign this Class Map to
control plane traffic only (CoPP).
layer2 Enter the keyword layer2 to specify a Layer 2 Class Map.
The default is
Layer 3.
Defaults Layer 3
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Class-map names can be 32 characters. Layer2 available on
the C-Series and S-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 E-Series Only: Expanded to add support for Layer 2.
Usage
Information
Packets arriving at the input interface are checked against the match criteria and
configured using this command to determine if the packet belongs to that class.
This command accesses CLASS-MAP mode, where the configuration commands
include thematch ip and match mac options.
Related
Commands
ip access-list extended — configures an extended IP ACL.
ip access-list standard — configures a standard IP ACL.
match ip access-group — configures the match criteria based on the access
control list (ACL).
match ip precedence — identifies the IP precedence values as match criteria.
match ip dscp — configures the match criteria based on the DSCP value.
match mac access-group — configures a match criterion for a class map based on
the contents of the designated MAC ACL.
Quality of Service (QoS)
1119