Installation guide

14 | The S6000 System
www.dell.com | support.dell.com
Table 2-2. 40G QSFP+/ 4x10G SFP+ Ethernet Port LEDs
Table 2-3. Management Ethernet Port LEDs
Basic Installation Requirements
Detailed installation instructions for the S6000 are provided in Chapter 3, Site Location and Preparation
and
Chapter 4, Install the S6000 . However, here is an initial list of components required for a successful
installation of the S6000:
• S6000 chassis
• If you ordered AC units, cables to connect the AC power source to each of the chassis’ AC power
supplies (country/regional configured)
• If you ordered DC units, cables to connect the DC power source to each of the chassis’ DC power
supplies
• Mounting brackets for rack installation (included)
• Screws for rack installation and #1 and #2 Phillips screwdrivers (not included)
• Ground cable (not included)
• Ground cable screws (included)
• Copper/fiber cables
Optional components for installation:
• Additional power supply units
• Additional fan modules
• Additional mounting brackets (if installing in a 4-post rack or cabinet)
Feature Detailed Description
Link/Activity LED • Off — No Link.
• Blinking green — Transmit/Receive is active.
• Solid green — Link up at 40Gbps/10Gbps speed.
Feature Detailed Description
Link LED • Off — No Link.
• Solid green
— Link on 10/100M/1G speed.
Activity LED • Off — No Link.
• Blinking green
— Transmit/Receive is active.