Command Line Reference Guide

DR Prio Displays the Designated Router priority value configured on the
interface (ip pim dr-priority command).
DR Displays the IP address of the Designated Router for that interface.
Example (#2)
FTOS#show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
S5000
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about PIM
neighbors that was discovered by PIM-SM snooping on a specified
VLAN. The valid VLAN IDs range is 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output from the show ip pim snooping neighbor command
shown in the Example below.
Field Description
Neighbor address Displays the IP address of the neighbor learned through PIM-SM
snooping.
Interface Displays the VLAN ID number and slot/port on which the PIM-SM-
enabled neighbor was discovered.
Uptime/expires Displays the amount of time the neighbor has been up followed by the
amount of time until the neighbor is removed from the multicast
routing table (that is, until the neighbor hold time expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
994