Command Line Reference Guide

line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you
can set the access conditions for the designated line.
S5000
Syntax
line {console 0 | vty number [end-number]}
Parameters
console 0 Enter the keyword console 0 to configure the console port. The
console option for the S5000 is
<0-0>.
vty number Enter the keyword vty followed by a number from 0 to 9 to configure
a virtual terminal line for Telnet sessions. The system supports 10
Telnet sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line
to configure. You can configure multiple lines at one time.
Defaults Not configured
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You cannot delete a terminal connection.
Related
Commands
access-class – restricts the incoming connections to a particular IP address in an IP access
control list (ACL).
password – specifies a password for users on terminal lines.
motd-banner
Enable a message of the day (MOTD) banner to appear when you log in to the system.
S5000
Syntax
motd-banner
Defaults Enabled on all lines.
Command Modes LINE
Command History
Version 9.0(1.3) Introduced on the S5000.
99