Command Line Reference Guide

• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. The range is 1 to 128.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
priority (OPTIONAL) Enter the priority used in Bootstrap election process. The
range is zero (0) to 255. The default is 192.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ip pim snooping
Enable PIM-SM snooping globally on a switch or on a VLAN interface.
S5000
Syntax
ip pim snooping [enable]
To disable PIM-SM snooping, use the no ip pim snooping [enable] command.
Defaults Disabled.
Command Modes
• CONFIGURATION: To configure PIM-SM snooping globally, enter the ip pim
snooping enable
command in global configuration mode.
• VLAN INTERFACE: To configure PIM-SM snooping on a VLAN interface, enter the ip
pim snooping command in VLAN interface configuration mode.
Command History
Version 9.0(1.3) Introduced on the S5000.
986