Command Line Reference Guide
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command is applied to the subsequent PIM-BSR. Existing BSR advertisements are
cleaned up by time out. Candidate RP advertisements can be cleaned using the clear ip
pim rp-mapping command.
ip pim bsr-candidate
Configure the PIM router to join the Bootstrap election process.
S50000
Syntax
ip pim bsr-candidate interface-type slot/port [hash-mask-
length] [priority]
To return to the default value, use the no ip pim bsr-candidate command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
hash-mask-
length
(OPTIONAL) Enter the hash mask length. The range is zero (0) to 32.
The default is 30.
priority
(OPTIONAL) Enter the priority used in Bootstrap election process. The
range is zero (0) to 255. The default is zero (0).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
980