Command Line Reference Guide
Parameters
redirect-list-
name
Enter the name of a redirect list.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
permit
Configure a rule for the redirect list.
S5000
Syntax
permit {ip-protocol-number | protocol-type} {source mask | any
| host ip-address} {destination mask | any | host ip-address}
[bit] [operators]
To remove the rule, use one of the following:
• If you know the filter sequence number, use the no seq sequence-number
syntax command.
• You can also use the no permit {ip-protocol-number | protocol-
type} {source mask | any | host ip-address} {destination
mask
| any | host ip-address} [bit] [operators] command.
Parameters
ip-protocol-
number
Enter a number from 0 to 255 for the protocol identified in the IP
protocol header.
protocol-type
Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
source
Enter the IP address of the network or host from which the packets
were sent.
mask
Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the filter.
host
ip-address
Enter the keyword host followed by the IP address to specify a host
IP address.
destination
Enter the IP address of the network or host to which the packets are
sent.
971