Command Line Reference Guide

ip redirect-group
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by
entering this command multiple times.
S5000
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group name
command.
Parameters
redirect-list-
name
Enter the name of a configured redirect list.
Defaults none
Command Modes INTERFACE (conf-if-vl-)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can apply any number of redirect-groups to an interface. A redirect list can contain any
number of configured rules. These rules includes the next-hop IP address where the incoming
traffic is to be redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop. Otherwise
the normal routing table is used to forward traffic. When a redirect-group is applied to an
interface and the next-hop is reachable, the rules are added into the PBR CAM region. When
incoming traffic hits an entry in the CAM, the traffic is redirected to the corresponding next-
hop IP address specified in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
Related
Commands
• show cam pbr – displays the content of the PBR CAM.
• show ip redirect-list – displays the redirect-list configuration.
ip redirect-list
Configure a redirect list and enter REDIRECT-LIST mode.
S5000
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
970