Command Line Reference Guide
Parameters
process-id
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use this command to isolate problems with inter-area and external routes. In OSPF inter-area
and external routes are calculated by adding LSA cost to the cost of reaching the router. If an
inter-area or external route is not of correct cost, the display can determine if the path to the
originating router is correct or not.
Example
FTOS#show ip ospf 1 topology
Router ID Flags Cost Nexthop Interface Area
3.3.3.3 E/B/-/ 1 20.0.0.3 Te 13/1 0
1.1.1.1 E/-/-/ 1 10.0.0.1 Te 7/1 1
FTOS#
show ip ospf virtual-links
Display the OSPF virtual links configured and is useful for debugging OSPF routing operations. If no OSPF virtual-links
are enabled on the switch, no output is generated.
S5000
Syntax
show ip ospf process-id virtual-links
Parameters
process-id
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output from the show ip ospf process-id virtual-
links
command shown in the Example below.
Virtual Link... This line specifies the OSPF neighbor to which the virtual link was
created and the link’s status.
964