Command Line Reference Guide

EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you delete all the network area commands for Area 0, the show ip ospf command
output does not list Area 0.
The following describes the output from the show ip ospf command shown in the Example
below.
Line Beginning
with
Description
Routing
Process...
Displays the OSPF process ID and the IP address associated with the
process ID.
Supports only... Displays the number of Type of Service (TOS) rouse supported.
SPF schedule... Displays the delay and hold time configured for this process ID.
Convergence
Level
Min LSA.... Displays the intervals set for LSA transmission and acceptance.
Number of... Displays the number and type of areas configured for this process ID.
Example
FTOS#show ip ospf 10
Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-
vrf
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area BACKBONE (0)
Number of interface in this area is 1
SPF algorithm executed 205 times
Area ranges are
FTOS#
Related
Commands
show ip ospf database – displays information about the OSPF routes configured.
show ip ospf interface – displays the OSPF interfaces configured.
show ip ospf neighbor – displays the OSPF neighbors configured.
show ip ospf virtual-links – displays the OSPF virtual links configured.
940