Command Line Reference Guide
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must have an IP address assigned to an interface to enter ROUTER OSPF mode and
configure OSPF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF Process ID
again in the system.
Example
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
S5000
Syntax
show config
Command Modes ROUTER OSPF
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface tengigabitethernet 0/1
FTOS(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
S5000
Syntax
show ip ospf process-id
Parameters
process-id
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Command Modes
• EXEC
939