Command Line Reference Guide
• If passive-interface default is specified, then save no passive-
interface interface into the running configuration.
No passive-interface default
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
debug ip ospf
Display debug information on OSPF. Entering the debug ip ospf commands enables OSPF debugging for the first
OSPF process.
S5000
Syntax
debug ip ospf process-id [bfd |event | packet | spf | database-
timer rate-limit]
To cancel the debug command, use the no debug ip ospf command.
Parameters
process-id
Enter the OSPF Process ID to clear a specific process. If no Process
ID is entered, all OSPF processes are cleared.
bfd (OPTIONAL) Enter the keyword bfd to debug only OSPF BFD
information.
event (OPTIONAL) Enter the keyword event to debug only OSPF event
information.
packet (OPTIONAL) Enter the keyword packet to debug only OSPF packet
information.
spf (OPTIONAL) Enter the keyword spf to display the Shortest Path First
information.
database-timer
rate-limit
(OPTIONAL) Enter the keywords database-timer rate-
limit to display the LSA throttling timer information.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output for the debug ip ospf command shown in the Example
below.
Field Description
8:14 Displays the time stamp.
OSPF Displays the OSPF process ID: instance ID.
934