Command Line Reference Guide

This interval must be greater than the expected round-trip time for a
packet to travel between two routers.
Defaults 5 seconds
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Set the time interval to a number large enough to prevent unnecessary retransmissions. For
example, the interval should be larger for interfaces connected to virtual links.
ip ospf transmit-delay
Set the estimated time elapsed to send a link state update packet on the interface.
S5000
Syntax
ip ospf transmit-delay seconds
To return to the default value, use the no ip ospf transmit-delay command.
Parameters
seconds Enter the number of seconds as the interval between retransmission.
The range is 1 to 3600. The default is 1 second.
This value must be greater than the transmission and propagation
delays for the interface.
Defaults 1 second
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
log-adjacency-changes
Set FTOS to send a Syslog message about changes in the OSPF adjacency state.
S5000
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes command.
Defaults Disabled.
930