Command Line Reference Guide

point-to-point Enter the keywords point-to-point to designate the interface
as part of a point-to-point network.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
Version 9.0(1.3) Introduced on the S5000.
ip ospf priority
Set the priority of the interface to determine the designated router for the OSPF network.
S5000
Syntax
ip ospf priority number
To return to the default setting, use the no ip ospf priority command.
Parameters
number Enter a number as the priority. The range is 0 to 255. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Setting a priority of 0 makes the router ineligible for election as a designated router or backup
designated router.
Use this command for interfaces connected to multi-access networks, not point-to-point
networks.
ip ospf retransmit-interval
Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the interface.
S5000
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the no ip ospf retransmit-interval command.
Parameters
seconds Enter the number of seconds as the interval between retransmission.
The range is 1 to 3600. The default is 5 seconds.
929