Command Line Reference Guide
area nssa
Specify an area as a not so stubby area (NSSA).
S5000
Syntax
area area-id nssa [default-information-originate] [no-
redistribution] [no-summary]
To delete an NSSA, use the no area area-id nssa command.
Parameters
area-id
Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a
number from zero (0) to 65535.
default-
information-
originate
(OPTIONAL) Allows external routing information to be imported into
the NSSA by using Type 7 default.
no-redistribution (OPTIONAL) Specify that the redistribute command should not
distribute routes into the NSSA. You should only use this command in
a NSSA area border router (ABR).
no-summary (OPTIONAL) Specify that no summary LSAs should be sent into the
NSSA.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
Version 9.0(1.3) Introduced on the S5000.
area range
Summarize routes matching an address/mask at an area border router (ABR).
S5000
Syntax
area area-id range ip-address mask mask [not-advertise]
To disable route summarization, use the no area area-id range ip-address
mask command.
Parameters
area-id
Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a
number from zero (0) to 65535.
ip-address
Specify an IP address in dotted decimal format.
mask
Specify a mask for the destination prefix. Enter the full mask (for
example, 255.255.255.0).
910