Command Line Reference Guide

Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show interfaces fibrechannel command to display information on the Fibre
Channel capability of a switch.
The following table describes the show fc switch output shown in the following example.
Switch Mode Fibre Channel mode of operation of an S5000 switch. Default: NPG
(configured as an NPIV proxy gateway).
Switch WWN Factory-assigned worldwide node (WWN) name of the S5000. The
S5000 WWN name is not user-configurable.
Example
FTOS# show fc switch
Switch Mode : NPG
Switch WWN : 10:00:5c:f9:dd:ef:10:c0
FTOS#
Related
Commands
interface fibrechannel — configures a Fibre Channel interface on the switch.
show interfaces fibrechannel — displays the configuration of a Fibre Channel interface.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
S5000
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the specified
map.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show qos dcb-map command to display the enhanced transmission selection
(ETS) and priority-based flow control (PFC) parameters used to configure server-facing
Ethernet ports. S5000 Ethernet ports are DCBx-enabled by default.
906