Command Line Reference Guide

You configure the association between a dedicated VLAN, which carries FCoE traffic from
server CNAs over the NPIV proxy gateway to a SAN fabric in which destination storage arrays
are installed, in an FCoE map by using the fabric id vlan command.
When you apply an FCoE map to a server-facing Ethernet port, the port is automatically
configured as a tagged member of the FCoE VLAN.
For more information about VLANs and the commands to configure them, refer to the Virtual
LAN (VLAN) Commands section of the Layer 2 chapter.
Example (Single
Range)
FTOS(conf)#interface vlan 10
FTOS(conf-if-vl-3)#
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication
between servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE
maps.
keepalive
In an FCoE map, enable the monitoring of FIP keepalive messages (if it is disabled).
S5000
Syntax
keepalive
Parameters None
Defaults FIP keepalive monitoring is enabled on Ethernet and Fibre Channel interfaces.
Command Modes FCOE MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
FIP keepalive (FKA) messaging is used to detect if other FCoE devices are reachable.
To remove FIP keepalive monitoring from an FCoE map, enter the no keepalive command.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication
between servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE
maps.
898