Command Line Reference Guide
FCoE-enabled servers and switches with the necessary parameters to log in to a SAN fabric.
Use the fcoe-map command to create an FCoE map.
On an S5000 NPIV proxy gateway, an FCoE map is applied on fabric-facing FC ports and server-
facing Ethernet ports. Use the fabric command to apply an FCoE map on an FC port. Use the
fcoe-map command to apply an FCoE map on an Ethernet port.
After you apply an FCoE map on an FC interface, when the port is enabled (no shutdown),
the NPIV proxy gateway starts sending FIP multicast advertisements on behalf of the FC port to
downstream servers in order to advertise the availability of a new FCF port on the FCoE VLAN.
To remove an FCoE map from an FC interface, enter the no fabric map-name command
in Interface configuration mode.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the communication
between servers and a SAN fabric.
interface fibrechannel — configures a Fibre Channel interface on the switch. .
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in FCoE
maps.
fabric-id vlan
In an FCoE map, configure the association between the dedicated VLAN used to carry FCoE traffic between servers and
a SAN, and the fabric where the desired storage arrays are installed.
S5000
Syntax
fabric-id fabric-num vlan vlan-id
Parameters
fabric-id
fabric-
num
Enter a fabric ID number that is the same as the ID number of the
dedicated VLAN used to carry FCoE storage traffic to the fabric
specified in the FCoE map.
vlan
vlan-id
Enter the ID number of the dedicated VLAN used to carry FCoE
storage traffic between servers and a SAN fabric and specified with
the vlan command in the FCoE map.
Defaults None
Command Modes FCOE MAP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
In the fabric-id vlan command, the fabric and VLAN ID numbers must be the same.
In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must be unique.
To remove a fabric-VLAN association from an FCoE map, enter the no fabric-id vlan
command.
893