Command Line Reference Guide

FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
FTOS(conf-if-te-5/0)#
enable
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may need to enter a
password.
S5000
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of FTOS. Range: 0 to
15.
Defaults 15
Command Modes EXEC
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Users entering EXEC Privilege mode or any other configured privilege level can access
configuration commands. To protect against unauthorized access, use the enable
password command to configure a password for the enable command at a specific
privilege level. If no privilege level is specified, the default is privilege level 15.
Related
Commands
enable password – configures a password for the enable command and to access a
privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
S5000
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-
update interval
command.
Parameters
interval seconds Enter the keyword interval followed by the polling interval in
seconds. Range: 120 to 6000 seconds. Default: 300 seconds (5
minutes).
89