Command Line Reference Guide

Related
Commands
mtu – sets the maximum link MTU (frame size) for an Ethernet interface.
ipv6 neighbor
Configure a static entry in the IPv6 neighbor discovery.
S5000
Syntax
ipv6 neighbor {ipv6-address} {interface-type slot/port}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighbor {
ipv6-address} {interface-type slot/port} command.
Parameters
ipv6-address
Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
interface-type
slot/port
Enter the interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface type are
listed below.
For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
hardware_addres
s
Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn format.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
887